COLOUR GUIDANCE: The swatches below are meant only as a guide - it is always advisable that you research colour or check a swatch card where possible available from most DIY stores. Lighting can affect the appearance of paint colour significantly and so if wishing to match very closely to a colour then please call us to discuss in detail. Check out this handy article for some tips CHOOSING PAINT COLOUR

Click on the magnifying glass in each swatch to see a picture of each up close. Please note that patterning where present will vary slightly.

NOTE: All solid surface tops are recommended to overhang the front and sides of a vanity unit. In all instances we add 15mm extra material to the front edge of the solid surface making a 500 deep unit feature a top which is 515mm. For the width, we reduce the cabinet size by 15mm to allow a 7.5mm overhang on the left and right of the unit. So a 1000mm wide unit would actually be 985mm wide to allow the top to overhang slightly (all sizes are +/- 3mm manufacturing tolerance).

It will fit into very tight spaces due to its low level design, ideal where space is often very limited and difficult to access. The Uniwaste™ will fit a waste of 1 ¼ inch and 1 ½ inch and 1 ¼ inch push fit or Polypipe at the bottom end. Uniwastes can be adapted at the bottom end for 1 ½ inch pipe with a McAlpine T29 or equivalent compression or solvent adapters.

Please choose the correct option below to select your handles. If your design selected on this page is just doors, drawers or a combination of both then please ensure the correct option below is selected.

This does NOT alter the product chosen in the store which is displayed on this page. If you wish to change to an alternative design of vanity unit then please visit the shop page.